Docs Marketing
4121 Guardian St.
Simi Valley, CA 93063
800-544-8706
How to Hang Wire with a Lagmaster Pole Tool
Adjust the telescoping tubes to the proper lengths.
Insert 1/4" x 3" accoustical lag screw into top slot.
Insert wire into side of slot, through the
hold in the lag screw. Then bend the wire end down.
Raise tool against beam or joist, rotate LagMaster until the Lag is at least
1" into the wood.
Lower the tool about two inches as shown
Rotate the tool again to twist the wire. LagMaster may be turned by hand
or by using a 1/2" variable speed drill. Caution: if using drill, do
not grip pole tightly with hand, but allow it to turn loosely.
